Opticon Sensors Europe BV H32 Manual Do Utilizador

Página de 29
Opticon 
H - 32  
Specifications Manual 
 
 
 
 
 
26 
12.  Regulatory Compliance 
12.1. Laser Safety (1D model) 
IEC 60825-1:2007 Laser Class 2 
CDRH Laser Class 2
 
FDA CDRH Laser class II. Complies with 21 CFR 1040.10 and 1040.11 except for 
deviations pursuant to laser notice No. 50 dated June 24, 2007. 
Class II laser devices are not considered to be hazardous when used for their 
intended purpose. Avoid staring into the laser beam.
 
12.2. EMC 
EN55022 
EN55024 
 
Federal Communications Commission (FCC) Statement 
15.21 
You are cautioned that changes or modifications not expressly approved by the  part 
responsible for compliance could void the user’s authority to operate the equipment. 
 
15.105(b) 
This equipment has been tested and found to comply with the limits for a Class B  digital 
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. 
This equipment generates uses and can radiate radio frequency energy and, if not  installed 
and used  in accordance with the instructions, may cause harmful interference  to radio 
communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures: 
 
-Reorient or relocate the receiving antenna. 
-Increase the separation between the equipment and receiver. 
-Connect the equipment into an outlet on a circuit different from that to which the  receiver is 
connected. 
-Consult the dealer or an experienced radio/TV technician for help. 
 
This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions:  
1) this device may not cause interference and 
2) this device must accept any interference, including interference that may cause undesired 
operation of the device.