Opticon Sensors Europe BV H29 Manual Do Utilizador
Barcode Data Capture
To scan a barcode label:
1. Point the scan window at the barcode.
2. Tap scan on the screen or press one of the scan buttons on the
1. Point the scan window at the barcode.
2. Tap scan on the screen or press one of the scan buttons on the
H-29(EU). The imager will project a green aiming bar. The green
aiming bar is used to position the barcode or object within the
field of view of the imager.
aiming bar is used to position the barcode or object within the
field of view of the imager.
3. Ensure the entire barcode is within the width area formed
by the green aiming bar, then either wait for the timeout or
release the scan key to capture the image. A white beam will
illuminates the barcode to capture and decode it.
release the scan key to capture the image. A white beam will
illuminates the barcode to capture and decode it.
FCC Compliance for H-29
This Device complies with Part 15 of the FCC rules, operation is
subject to the following two conditions:
(1) This device may not cause harmful interference and,
(2) This device must accept any interference received, including
interference that may cause undesired operation.
subject to the following two conditions:
(1) This device may not cause harmful interference and,
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This device has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation if this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation if this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
15.21 Statement
You are cautioned that changes or modifications not expressly
approved by the part responsible for compliance could void the
user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in
You are cautioned that changes or modifications not expressly
approved by the part responsible for compliance could void the
user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of
1cm between the radiator and your body.
should be installed and operated with a minimum distance of
1cm between the radiator and your body.
General Safety Rules
Please read this Guide thoroughly and carefully before you start
using this device. Use only the components and accessories
supplied by the manufacturer for H-29(EU) you are using.
using this device. Use only the components and accessories
supplied by the manufacturer for H-29(EU) you are using.
Do not attempt to disassemble H-29(EU), as it does not contain
parts that can be repaired by the user. Any tampering will void
the warranty. When replacing the battery pack or at the end of life
of H-29(EU) disposal must be performed in compliance with the
laws in force in your jurisdiction. Do not submerge H-29(EU) in any
liquid (water, detergent, etc).
parts that can be repaired by the user. Any tampering will void
the warranty. When replacing the battery pack or at the end of life
of H-29(EU) disposal must be performed in compliance with the
laws in force in your jurisdiction. Do not submerge H-29(EU) in any
liquid (water, detergent, etc).
For Safe Use Concern, Please Pay Special Attention on the
Following Notices:
The manufacturer has taken safety as first priority during design
stage. To avoid any potential accident, please be cautious on the
following alert points:
• Please do not stock this device under conditions of high
Following Notices:
The manufacturer has taken safety as first priority during design
stage. To avoid any potential accident, please be cautious on the
following alert points:
• Please do not stock this device under conditions of high
temperature which will cause the battery to become hot, fire, or
broken etc. leading to failure and safety concerns.
broken etc. leading to failure and safety concerns.
• When the charging time is noticed longer than standard required
(CHARGING LED, RED, is still ON), please stop charging immediately.
• Please charge this device in place without any water-spray or
moisture.
• Ensure that the AC adapter can freely dissipate its heat, don’t
cover the AC adapter with objects, such as curtains.
• Never use damaged AC adapters, immediately replace it with a
new approved AC adapter.
• Please do not put any heavy weight on top of this device as it
might cause device enclosure crack then lead to cutting injury.
• Please do not use wet hand to pull out the AC adapter which
might cause electric shock.
• Please do not use H-29(EU) AC adapter on any other different
devices.
• Please do not put the device into water which may cause short-
circuit or fire.
• Please do not put this device in place close to open fire.
• If the power or USB cable is seriously twisted or broken, please stop
• If the power or USB cable is seriously twisted or broken, please stop
using immediately or it may cause electric shock, short-circuit, or fire.
• Please stop using immediately when there is any unusual smell
or overheat during charging or operation.
• Please stop using immediately when there is any liquid or dew
on the device.
• Please do not use the AC adapter outdoor. Please do not wrap
the AC adapter with cloth which will block heat dissipation and
will cause electric shock or fire.
will cause electric shock or fire.
• Except charging, please remove the AC adapter plug from the
wall AC outlet socket or it will cause fire accident.
Important Notices When Using
• Before replacing battery pack due to failure, shortened life, or
• Before replacing battery pack due to failure, shortened life, or
any other unusual behavior, please confirm if the device has
been used correctly and there has no user operation issue
involved.
been used correctly and there has no user operation issue
involved.
• It is possible there will be some missed data or interference
encountered during the wireless transmission. It is not a
situation can be controlled by the manufacturer.
situation can be controlled by the manufacturer.
• Please do not use any alcohol, benzene, organic solvent, cleaner
liquid, or steel-wool on the surface of this device.
• Please do not scratch the surface of Scan Window in any way as
which will cause problem on barcode scanning.
Audio Safety
To prevent possible hearing damage, do no listen at high volume for
long periods.
To prevent possible hearing damage, do no listen at high volume for
long periods.
European Union Regulatory Notes
Hereby, Opticon Sensors Europe B.V. declares that the radio
equipment type H-29(EU) is in compliance with Directive 2014/53/
EU. The WiFi operating in the bands 5150 – 5350 MHz shall be
restricted to indoor use for the following countries: AT, BE, BG, CH,
CY, CZ, DE, DK, EE, EL, ES, FI, FR, HR, HU, IE, IS, IT, LI, LT, LU, LV,
MT, NL, NO, PL, PT, RO, SE, SI, SK, TR, UK.
Hereby, Opticon Sensors Europe B.V. declares that the radio
equipment type H-29(EU) is in compliance with Directive 2014/53/
EU. The WiFi operating in the bands 5150 – 5350 MHz shall be
restricted to indoor use for the following countries: AT, BE, BG, CH,
CY, CZ, DE, DK, EE, EL, ES, FI, FR, HR, HU, IE, IS, IT, LI, LT, LU, LV,
MT, NL, NO, PL, PT, RO, SE, SI, SK, TR, UK.
The full text of the Declaration of Conformity is available at the
following internet address: https://opticon.com/product/h-29/
following internet address: https://opticon.com/product/h-29/
SAR Compliance (H-29EU)
SAR Compliance (H-29)
SAR Information (for EU):
SAR Information (for EU):
Head: 0.328 W/kg@ 10g (CE)
Head: 0.288 W/kg@ 10g (CE)
Body: 1.600 W/kg@ 10g (CE)
Body: 0.320 W/kg@ 10g CE)
Body - worn Operation
This device was tested for typical body-worn operations. A minimum
separation distance must be maintained between the user’s body and
the handset, including the antenna: 0.5 cm to comply with the RF
exposure requirements in Europe third-party belt-clips, holsters and
similar accessories used by this device should not contain any metallic
components. Body-warn accessories that do not meet these requirements
may not comply with RF exposure requirements and should be avoided.
This device was tested for typical body-worn operations. A minimum
separation distance must be maintained between the user’s body and
the handset, including the antenna: 0.5 cm to comply with the RF
exposure requirements in Europe third-party belt-clips, holsters and
similar accessories used by this device should not contain any metallic
components. Body-warn accessories that do not meet these requirements
may not comply with RF exposure requirements and should be avoided.
Power and Frequency Ranges
H-29EU
H-29EU
Radio Type
Description
Frequency
Maximum
Output
Output
Bluetooth
Bluetooth BR+EDR
2400~2483.5 MHz
4dBm
Bluetooth 4.0-LE
2400~2483.5 MHz
4dBm
WLAN
2.4GHz
2400~2483.5 MHz
17dBm
5GHz
5150~5350 MHz
21dBm
5470~5725 MHz
22dBm
GSM
GSM 900
880~915 MHz
32dBm
GSM 1800
1710~1785 MHz
30.5dBm
WCDMA
WCDMA Band I
1920~1980 MHz
24dBm
WCDMA Band VIII
880~915 MHz
24dBm
LTE
LTE Band 1
1920~1980 MHz
23dBm
LTE Band 3
1710~1785 MHz
23dBm
LTE Band 7
2500~2570 MHz
23dBm
LTE Band 8
880~915 MHz
23dBm
LTE Band 20
832~862 MHz
23dBm
LTE Band 38
2570~2620 MHz
24dBm
LTE Band 40
2300~2400 MHz
23dBm
other
NFC
13.56 MHz
GPS
1575.42 MHz
H-29
Radio Type
Description
Frequency
Maximum
Output
Output
Bluetooth
Bluetooth BR+EDR
2400~2483.5 MHz
4dBm
Bluetooth 4.0-LE
2400~2483.5 MHz
4dBm
WLAN
2.4GHz
2400~2483.5 MHz
17dBm
5GHz
5150~5350 MHz
21dBm
5470~5725 MHz
22dBm
other
NFC
13.56 MHz
Documentation
Documentation, drivers and software updates for the H-29(EU) are
available at:
available at:
www.opticon.com
Opticon Sensors Europe BV
Opaallaan 35, 2132 XV Hoofddorp, the Netherlands.
© Copyright Opticon. All rights reserved. This information is subject
to change without prior notice. For availability, contact your local
representative.
Opaallaan 35, 2132 XV Hoofddorp, the Netherlands.
© Copyright Opticon. All rights reserved. This information is subject
to change without prior notice. For availability, contact your local
representative.