Opticon Sensors Europe BV PX20 Manual Do Utilizador
24
Opticon
PX-20
Specifications Manual
14. Regulatory Compliance
14.1. Product Safety
EN 60950-1:2006+A11:2009+A1:2010+A12:2011
Lamp classification: IEC62471:2006 Exempt Group
14.2. EMC
EN55022
EN55024
FCC Part 15 Subpart B Class B and Part 15 Subpart C: This device complies with
part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to
operate this equipment. (Example: Use only shielded interface cables when
connecting to computer or peripheral devices).
approved by the party responsible for compliance could void the user’s authority to
operate this equipment. (Example: Use only shielded interface cables when
connecting to computer or peripheral devices).
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
uncontrolled environment.
14.3. REACH
Regulation (EC1907/2006) compliance
14.4. RoHS
RoHS: The restriction of the use of certain hazardous substances in electrical and
electronic equipment, 2002/95 EC.
electronic equipment, 2002/95 EC.