AeroScout EX3200 Manual Do Utilizador

Connectors Panel 

Figure 4 describes the EX3200 connector panel (bottom panel).  

 

1. Ethernet LAN Connection – RJ-45 interface. In a configuration that uses 
physical Ethernet cable connection to the LAN, the network cable is attached 
here. Permanent connection to a wired network is not mandatory. However 
you must have a wired connection for configuring the EX3200. In addition, 
some of the monitoring functions will not be available if the EX3200 is not 
wired. This connection is also used for Power over Ethernet (PoE, 802.3af). 

2. Power jack – Accepts an input voltage of 12V DC. When PoE is used, this 
connection is not used. 

3. Chain IN Connector – RJ-45 connector. This connector is used for 
receiving power, serial interface and data from chained EX3200s. 

4. Chain OUT and Control Connector – RJ-45 connector. This connector 
is used for distributing power, serial interface and data to chained EX3200s.  

5. Mater/Salve Switch – This Switch set the EX3200 role in a chain Master 
or Slave.