CipherLab Co. Ltd. M0010A Manual Do Utilizador

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

This equipment complies with the requirements for SAR compliance as stipulated in FCC regulations. The user

can safely use this equipment when handheld and when body-worn.  Beltclips, holsters or similar accessoires

with a metallic component may not be used. The equipment must not be co-located or operating in conjunction

with any other transmitter or antenna. Max. reported SAR values: 850MHz: 0.562W/kg (body);

1900MHz: 0.230W/kg (body); 2.4GHz: 0.041W/kg (body).  

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE 

FOLLOWING TWO CONDITIONS:   

(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND   

(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE 

THAT MAY CAUSE UNDESIRED OPERATION. 

 

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instruction, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 

following measures: 

 
• Reorient or relocate the receiving antenna. 
• Increase the separation between the equipment and receiver. 

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

• Consult the dealer or an experienced radio/TV technician for help. 

 
Notice: 

(1) A Unshielded-type power cord is required in order to meet FCC emission limits and also to prevent   

interference to the nearby radio and television reception. It is essential that only the supplied power   

cord by used. 

(2) Use only shielded cables to connect I/O devices to this equipment. 

(3) Changes or modifications not expressly approved by the party responsible for compliance could void the 

user’s authority to operate the equipment. 

This equipment marketed in USA is restricted by firmware to only operate on 2.4G channel 1-11.