ICP DAS Co. Ltd. ZBUPH0001 Manual Do Utilizador

   

 

 

                       

Product #:ZB-UPH01   

 
Confidential  

Page 

14/14 

 
 

Doc. #: ZB-UPH01 Reference Note <Rev. 0.9>   

This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC 

compliance requirement of the end product, which integrates this module. 

 

Any changes or modifications not expressly approved by the manufacturer could void the user's 

authority to operate this equipment. 

 

In the users manual of the end product, the end user has to be informed to keep at least 20cm 

separation with the antenna while this end product is installed and operated. The end user has to be 

informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be 

satisfied. The end user has to also be informed that any changes or modifications not expressly 

approved by the manufacturer could void the user's authority to operate this equipment. If the size of 

the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be 

available in the users manual: This device complies with Part 15 of FCC rules. Operation is subject to 

the following two conditions: (1) this device may not cause harmful interference and (2) this device must 

accept any interference received, including interference that may cause undesired operation. 

 

The final end product must be labeled in a visible area with the following " Contains TX FCC ID: 

Q6MZBUPH0001 ". If the size of the end product is larger than 8x10cm, then the following FCC part 

15.19 statement has to also be available on the label:    This device complies with Part 15 of FCC rules. 

Operation is subject to the following two conditions: (1) this device may not cause harmful interference 

and (2) this device must accept any interference received, including interference that may cause 

undesired operation.