ZTE Corporation AC682 Manual Do Utilizador

Página de 20
RF Exposure Information (SAR) 
 
This product meets the government s requirements for exposure to radio waves. 
This product is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) 
energy set by the Federal Communications Commission of the U.S. Government.     
 
The exposure standard for this product employs a unit of measurement known as the Specific Absorption Rate, or 
SAR.    The SAR limit set by the FCC is 1.6W/kg.   
*
Tests for SAR are conducted using standard operating positions 
accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands.   
Although  the  SAR  is  determined  at  the  highest  certified  power  level,  the  actual  SAR  level  of  the  device  while 
operating can be well below the maximum value.    This is because the product is designed to operate at multiple 
power  levels  so  as  to  use  only  the  poser  required  to  reach  the  network.    In  general,  the  closer  you  are  to  a 
wireless base station antenna, the lower the power output. 
 
The highest SAR value for the model product as reported to the FCC when worn on the body, as described in this 
user guide, is 
0.868
 W/kg (Body-worn measurements differ among devices, depending upon available accessories 
and FCC requirements.) 
 
While there may be differences between the SAR levels of various products and at various positions, they all meet 
the government requirement. 
 
The FCC has granted an Equipment Authorization for this model product with all reported SAR levels evaluated as 
in  compliance  with the  FCC  RF exposure  guidelines.    SAR  information on this  model  product  is  on file  with the 
FCC  and  can  be  found  under  the  Display  Grant  section  o
  after  searching  on  FCC  ID: 
Q78-AC682 
 
 
For body worn operation, this product has been tested and meets the FCC RF exposure guidelines for use with an 
accessory  that  contains  no  metal  and  the  positions  the  handset  a  minimum  of
  0.5cm
  from  the  body.    Use  of 
other accessories may not ensure compliance with FCC RF exposure guidelines.    If you do no t use a body-worn 
accessory and are not holding the product at the ear, position the handset a minimum of 
0.5 cm
 from your body 
when the product is switched on.