Cardo Systems AWHS01 Manual Do Utilizador

Main Features
• Call can be answered and terminated
  either from  Headset or from  phone.
   Audio is heard from the Headset. The
    link between the Adapter and the
   Headset is closed automatically.
• Call can be initiated from the p h o n e ;
      audio is heard from the Headset.
• Supports voice dialing with phones that

equipped accordingly.

Setting the Advanced  mode
To  set your Headset to the Advanced
mode, press and hold the Mute/Set button
on the Headset for 5 seconds until the
red light indicator starts flashing once. To
toggle between Normal and Advanced
mode, press & hold the Mute/Set button
on the Headset for 5 seconds again. When
the red light indicator flashes once, you
are in Advanced mode, two red flashes
indicate Normal mode. Each additional
pressure of the Mute/Set button toggles
between the two modes.

Answering a Call
When your mobile phone is ringing you
will hear the ring tone either directly on
the Headset or from the phone. To answer
the call from the Headset, press the CTRL
button briefly. IMPORTANT:  After pressing
the CTRL button, wait a few seconds until
you hear a sound on the Headset. Pressing
the CTRL button briefly again will
disconnect the call. Alternatively you can
answer the call by using the keypad of

your mobile phone. Audio connection
between Headset and phone will
automatically be established.

Terminating a Call
To terminate a call, press briefly the CTRL
button. A sound will be heard, confirming
the disconnection. Wait at least three
seconds before you press the CTRL button
again. Alternatively, you can terminate a
call by using the keys of your mobile
phone. Audio connection between the
Headset and phone will automatically
be disconnected. No further action on
your part is required if the other party
terminates the call.

Voice Dialing / Initiating a Call
This feature is only available with mobile
phones equipped with voice activation
technology. To use voice activation you
must first assign voice tags to the desired
parties among your contacts (if you are
not familiar with this procedure, please
refer to the manual of your mobile phone).

While your phone is ON but idle and not
ringing, press briefly the CTRL button
followed by a short beep. After the beep,
pronounce the name of the party you
wish to call and wait for feedback from
the phone. The type of feedback depends
on your phone (voice confirmation or no
confirmation). Alternatively you can initiate
a call by using the keypad of your mobile
phone. Audio connection between

Headset Manual   23