Hewlett Packard Enterprise Company AP175SDR Manual Do Utilizador
16
Aruba AP-175 Outdoor Access Point
| Installation Guide
Second Wrapping of Tape
1. Cut a 4” (100 mm) strip of electrical tape from the roll.
2. Where you begin wrapping depends on the orientation of the antenna. Water should flow in the opposite
direction of the wrapping to prevent water from entering the connector between the layers of tape.
Therefore, if the antenna is facing up, you should begin wrapping at the AP end of the connector. This
will ensure that your fourth and final layer will be layered correctly. Conversely, if your antenna is facing
down, you should begin wrapping on the antenna end of the connector.
will ensure that your fourth and final layer will be layered correctly. Conversely, if your antenna is facing
down, you should begin wrapping on the antenna end of the connector.
3. After completing the fourth layer of tape, check your work to ensure there are no places where water
can collect. If there are, you must smooth out those areas with additional layers of tape or remove the
weatherproofing and begin again.
weatherproofing and begin again.
Figure 11 Completed Wrapping (Antenna on Top of AP)
4. Repeat this process for all connectors.
First and third layers wrap
top to bottom
AP175_15
Rubber will
be wrapped
with 4 layers
of tape
Second and final layers wrap
bottom to top
Pieces of tape as needed