Hewlett Packard Enterprise Company AP175SDR Manual Do Utilizador
4
Aruba AP-175 Outdoor Access Point
| Installation Guide
USB Console Interface
A USB serial console port is provided for connection to a terminal, allowing direct local management. Use
the included USB console cable to connect to the AP. You can download the necessary driver for USB-
UART adapter from
the included USB console cable to connect to the AP. You can download the necessary driver for USB-
UART adapter from
support.arubanetworks.com
under the Tools & Resources tab.
Use the following setting to access the terminal:
Power Interface
The type of power interface on your AP-175 depends on which model you have purchased.
AP-175P: This version does not include a power interface since it is only powered by PoE+ (802.3at).
AP-175AC: 1x AC power connector
AP-175DC: 1x DC power connector
Ethernet Interface
The AP-175 is equipped with a 10/100/1000Base-T Gigabit Ethernet port for wired network connectivity. On
the AP-175P, this port also supports IEEE 802.3at Power over Ethernet (PoE), accepting 48 VDC as a
standards-defined powered device (PD) from a power sourcing equipment (PSE) device, such as a PoE
midspan injector. Inversely, the AP-175AC and AP-175DC can act as a PSE device to provide IEEE802.3af
PoE power to devices connected to the Ethernet port.
the AP-175P, this port also supports IEEE 802.3at Power over Ethernet (PoE), accepting 48 VDC as a
standards-defined powered device (PD) from a power sourcing equipment (PSE) device, such as a PoE
midspan injector. Inversely, the AP-175AC and AP-175DC can act as a PSE device to provide IEEE802.3af
PoE power to devices connected to the Ethernet port.
Grounding Point
Always remember to protect your AP-175 by installing grounding lines. The ground connection must be
complete before connecting power to the AP-175 enclosure. Ensure that the resistance is less than 5 ohm
between the ground termination point and the grounding tier.
complete before connecting power to the AP-175 enclosure. Ensure that the resistance is less than 5 ohm
between the ground termination point and the grounding tier.
AP-175P LED Status Indicators
The AP-175 include visual indicators for power, link, and radio status. Additionally, each radio has a four-
LED array that indicates received signal strength (RSSI).
LED array that indicates received signal strength (RSSI).
Table 1 Console Settings
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
9600
8
None
1 None
!
Do not connect a DC power cable to an AP-175AC or an AC power cable to a AP-175DC.
!
For the AP-175AC, only use the AC power cord with model number CBL-AC-INTL.
For the AP-175DC, only use DC power cord with model number CBL-DC-WW.
The RSSI LED indicators represent varying degrees in the RSSI level. The absence of a signal is indicated by no
LED response, and full signal strength is indicated when all four LEDs are active and lit.