Hewlett Packard Enterprise Company APEX0102 Manual Do Utilizador
4
AP-277 Outdoor Access Point
| Installation Guide
Table 2
AP-277 LED Meanings during Operation
USB Console Port
The USB Micro-B console port allows you to connect the AP to a terminal or a laptop for direct local
management. Use the included USB console cable to connect the AP. You can download the
necessary driver for USB-UART adapter from
support.arubanetworks.com
under the Tools &
Resources tab.
Use the following setting to access the terminal:
Use the following setting to access the terminal:
Ethernet Ports
AP-277 is equipped with two10/100/1000Base-T (RJ-45) Gigabit Ethernet ports (WAN and LAN port)
for wired network connectivity. The WAN port supports 802.3at Power over Ethernet (PoE), accepting
48 VDC (nominal) as a standard defined Powered Device (PD) from a Power Sourcing Equipment (PSE)
such as a PoE midspan injector.
These ports have RJ-45 female connectors with the pin-outs shown in
These ports have RJ-45 female connectors with the pin-outs shown in
Figure 3
.
Figure 3
Gigabit Ethernet Port Pin-Out
Reset Button
The reset button can be used to return the AP to factory default settings. To reset the AP:
1. Power off the AP.
2. Press and hold the reset button using a small, narrow object, such as a paperclip.
3. Power-on the AP without releasing the reset button. The system LED will flash within 5 seconds.
4. Release the reset button.
The system LED will flash again within 15 seconds indicating that the reset is completed. The AP will
1. Power off the AP.
2. Press and hold the reset button using a small, narrow object, such as a paperclip.
3. Power-on the AP without releasing the reset button. The system LED will flash within 5 seconds.
4. Release the reset button.
The system LED will flash again within 15 seconds indicating that the reset is completed. The AP will
now continue to boot with the factory default settings.
LED
Color/State
Meaning
System LED Solid Red
General fault
One blink off every 3
seconds
Radio 0 fault (5 GHz)
Two quick blink off 0.5
seconds apart cycled every
3 seconds
Radio 1 fault (2.4GHz)
Table 3
Console Settings
Baud Rate Data Bits Parity
Stop Bits
Flow Control
9600
8
None
1 None
1000Base-T Gigabit
Ethernet Port
RJ-45 Female
Pin-Out
Pin-Out
Signal Name
1
2
3
4
5
6
7
8
2
3
4
5
6
7
8
BI_DC+
BI_DC-
BI_DC-
BI_DD+
BI_DD-
BI_DD-
BI_DA+
BI_DA-
BI_DB+
BI_DA-
BI_DB+
BI_DB-
Function
Bi-directional pair +C, POE Positive
Bi-directional pair -C, POE Positive
Bi-directional pair -C, POE Positive
Bi-directional pair +D, POE Negative
Bi-directional pair -D, POE Negative
Bi-directional pair -D, POE Negative
Bi-directional pair +A, POE Negative
Bi-directional pair -A, POE Negative
Bi-directional pair +B, POE Positive
Bi-directional pair -A, POE Negative
Bi-directional pair +B, POE Positive
Bi-directional pair -B, POE Positive