Hewlett Packard Enterprise Company APIN0207 Manual Do Utilizador
Aruba 207 Series Wireless Access Point
Regulatory Compliance and Safety Information Guide
0511889-03 |
September 2016
1
Introduction
This document contains domestic and international regulatory compliance and safety information for the access
point. To ensure that this device complies with the regulatory standards for your region, please refer to the
sections below.
point. To ensure that this device complies with the regulatory standards for your region, please refer to the
sections below.
Electrical and Environmental Specifications
For additional specifications on this product, please refer to the product data sheet at
www.arubanetworks.com.
Electrical
Ethernet:
One 10/100/1000 Base-T auto-sensing Ethernet interface (RJ-45)
Power:
Maximum power consumption (excluding USB):13.5W (PoE) or 12W (DC)
Direct DC source: 12Vdc nominal, +/- 5%
Power over Ethernet (PoE): 802.3af complaint source
Connect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.
Environmental
Operating:
Temperature: 0° C to +40° C (+32° F to +104° F)
Humidity: 5% to 93% non-condensing
Storage and transport
Temperature: -40° C to +70° C (40° F to +158° F)
Regulatory Information
The following regulatory model names apply to the 207 Series access points:
AP-207/IAP-207: APIN0207
Aruba provides a multi-language document that contains country-specific restrictions and additional safety and
regulatory information for all Aruba access points. This document can be viewed or downloaded from the
following location:
regulatory information for all Aruba access points. This document can be viewed or downloaded from the
following location:
www.arubanetworks.com/safety_addendum
.
All Aruba access points should be professionally installed by an Aruba Certified Mobility Professional (ACMP).
The installer is responsible for ensuring that grounding is available and meets applicable national and electrical
codes.
The installer is responsible for ensuring that grounding is available and meets applicable national and electrical
codes.
Tous les points d'accès Aruba doivent impérativement être installés par un professionnel agréé. Ce dernier
doit s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes
électriques nationaux en vigueur.
doit s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes
électriques nationaux en vigueur.
If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL
listed, without an output rated 12Vdc, minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into
a standard power receptacle in the US and Canada.
listed, without an output rated 12Vdc, minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into
a standard power receptacle in the US and Canada.