Hewlett Packard Enterprise Company APIN0318 Manual Do Utilizador

| Installation Guide

The USB Micro-B console port allows you to connect the access point to a laptop or serial console for direct 

management. Use the included USB console cable to connect the access point. You can download the necessary 

driver for USB-UART adapter from 

support.arubanetworks.com 

under the Tools & Resources tab.

Use the following setting to access the terminal:

The reset button can be used to return the access point to factory default settings. To reset the access point:
1. Power off the access point.
2. Press and hold the reset button using a small, narrow object, such as a paper clip.
3. Power-on the access point without releasing the reset button. The system LED will flash within 5 seconds.
4. Release the reset button.
The system LED will flash again within 15 seconds indicating that the reset is completed. The access point will 

now continue to boot with the factory default settings.

System LED Off

No power to AP

Red

Initial power-up 

Green - Flashing

AP booting

Green - Steady

AP ready and 1000Mbps Ethernet link established. The LED 

turns off after 1200 seconds

Green - Yellow, 6 seconds 

period

AP ready and 10/100Mbps Ethernet link established. The LED 

turns off after 1200 seconds

System LED Solid Red

General fault

One blink off every 3 

seconds

Radio 0 fault (5 GHz)

Two quick blink off 0.5 

seconds apart cycled every 

3 seconds

Radio 1 fault (2.4GHz)

You need a proper Allen wrench (8mm) to open the cover of the USB Console port.

9600

8

None

1 None