Hewlett Packard Enterprise Company APIN0344345 Manual Do Utilizador
Precautions for products installed in racks and cabinets
Materials handling
To reduce the risk of personal injury or damage to the equipment:
•
Observe local occupational health and safety requirements and guidelines for handling
materials.
materials.
•
Obtain assistance to lift and stabilize the product during installation or removal.
•
Remove all pluggable power supplies and modules to reduce the weight of the product.
•
Be careful when pressing the rail release latches and sliding the product into the rack. The
slide rails could pinch your fingertips.
slide rails could pinch your fingertips.
Rack stability
To reduce the risk of personal injury or damage to the equipment, the rack must be secured
adequately to prevent it from becoming unstable and/or falling over.
adequately to prevent it from becoming unstable and/or falling over.
•
Extend the leveling jacks to the floor.
•
Ensure that the full weight of the rack rests on the leveling jacks.
•
Install stabilizing feet on the rack.
•
In a multiple-rack installation, fasten the racks together securely.
•
Extend only one rack component at a time. Racks can become unstable if more than one
component is extended.
component is extended.
•
Load the rack from the bottom up, starting with the heaviest component.
•
Ensure that the component is properly mated with the rails, or the rails may be unstable.
•
Do not attempt to move a fully loaded rack. Remove components from the rack before moving
it.
it.
•
Do not attempt to move a rack on an incline that is greater than 10 degrees from horizontal.
Cabinet safety
WARNING!
Cabinets are heavy even when empty. Exercise caution when moving cabinets
whether equipment is installed in the cabinet or not. Avoid rolling cabinets on rough or uneven
surfaces or inclines greater than 10 degrees. Unloading cabinets from the pallet and movement
of cabinets should be performed by at least two people.
surfaces or inclines greater than 10 degrees. Unloading cabinets from the pallet and movement
of cabinets should be performed by at least two people.
Slideable products are not to be extended from the cabinet while the equipment is on the shipping
pallet. The cabinet must be unloaded from the pallet and all anti-tip devices properly installed
prior to extending any slideable product.
pallet. The cabinet must be unloaded from the pallet and all anti-tip devices properly installed
prior to extending any slideable product.
Once installed, all anti-tip devices must remain in place to maintain stability. Only one slideable
product must be extended at a time.
product must be extended at a time.
Failure to follow these precautions can result in damage to equipment or injury to personnel.
Precautions for modems, telecommunications, or LAN options
To reduce the risk of exposure to shock from telephone ringing voltages:
•
•
Do not connect or use a modem or telephone (other than a cordless type) during a lightning
storm.
storm.
•
Do not use a telephone line to report a gas leak while you are in the vicinity of the leak.
•
Do not connect or use a modem or telephone cable in a wet location.
Precautions for products installed in racks and cabinets
13