Hewlett Packard Enterprise Company ARUBA70 Manual Do Utilizador
AP Deployment
25
Chapter 3
C
HAPTER
3
AP Deployment
This chapter covers the following topics:
z
Physical mounting of the Aruba 70
z
Connecting the required cables
Mounting the Aruba 70
When provisioning is complete, mount the Aruba 70 at its intended service location.
The Aruba 70 Access Points with or without external antennas are intended only for
installation in Environment A as defined in IEEE 802.3.af. All interconnected equipment
must be contained within the same building, including the interconnected equipment's
associated LAN connections. (When using an external antenna, 5.150 to 5.250 MHz are
blocked.)
installation in Environment A as defined in IEEE 802.3.af. All interconnected equipment
must be contained within the same building, including the interconnected equipment's
associated LAN connections. (When using an external antenna, 5.150 to 5.250 MHz are
blocked.)
Select a location as close as possible to the center of the intended coverage area. If necessary,
use the Aruba RF Plan site survey tool to determine the optimum locations for your access
points and air monitors.
use the Aruba RF Plan site survey tool to determine the optimum locations for your access
points and air monitors.
The service location should be free from obstructions or obvious sources of interference.
Normally, the higher you place an access point or air monitor, the better its performance.
Normally, the higher you place an access point or air monitor, the better its performance.
If external antennas are used, make sure that they and their associated wiring are located
entirely indoors. TheAruba 70 and any optional external antennas are not suitable for outside
use.
entirely indoors. TheAruba 70 and any optional external antennas are not suitable for outside
use.