Hewlett Packard Enterprise Company MSR4000DFS Manual Do Utilizador

| Installation Guide

1. Before wrapping the antennas, locate the weep holes (

Figure 6

). Weep holes allow condensation that 

has built up inside the antenna to escape.

2. Prepare the antenna connector by cleaning and drying it.

3. Cut a 4” (100 mm) strip of electrical tape from the roll. Pre-cutting the tape into strips makes in easier to 

maneuver the tape around the antennas and other components of the router’s case.

4. Beginning just below the weep holes, tightly wrap the connection with a layer of the 3/4” (19mm) 

electrical tape. Overlap the tape to a half-width. 

5. Repeat steps 3 and 4 until the wrapping extends all the way to the router’s case.

Figure 10  First Wrapping of Tape 

Wrap tape from

just above knurled

section to base of

antenna mount

Pieces of tape as needed

Leave

weep holes

uncovered