Hewlett Packard Enterprise Company MSR4000DFS Manual Do Utilizador

| Installation Guide

1. Begin by marking the screw points on the wall in the location you have selected.

a. Put the mounting bracket on the installation position against the wall.

b. Mark four expansion screw holes on the wall.

Figure 25  Position of the Screw Holes on the Mounting Bracket

2. Use a drill to create four holes on the four markings you created in the previous step. 

3. Install wall (masonry) anchors.

a. Insert a masonry anchor into each drilled hole.

b. Tap the flat end of the anchor with a rubber hammer until the anchor is flush with the wall surface.

4. Attach the mounting bracket to the wall.

a. Align the four holes in the mounting bracket with the anchors and insert four expansion screws 

through the installation holes into the anchors. 

b. Adjust the position of the mounting bracket and tighten the expansion screws. 

5. Hang the MSR4000 on the bracket. 

a. Screw the two M4 x16 bolts into the holes on the back of the MSR4000. 

b. Align the two M4 x16 bolts on the back of MSR4000 with the holes on the mounting bracket and hang 

the MSR4000 on the mounting bracket.

Figure 26  Hanging the MSR4000 on the Mounting Bracket