Controlled Electronic Management Systems Ltd INFOPROX Manual Do Utilizador

InfoProx Entry 

 

Getting Started 

The following list displays the order of tasks you must complete for proper installation 
and configuration of the Door Control Unit. 

1. 

Before installing the hardware, make sure you have the proper tools and 
materials, as listed:  

·  Electrical containment box 

·  Nominal 12 Volt power source 

·  Containment box adapter plate, used for US installations (provided) 

·  2-pair (Belden 8723) cable for power and data with 4-pin socket 

·  5-pair cable for inputs and output with 10-pin socket 

·  2-pair (Belden 8723) cable with 4-pin socket for connection to exit reader 

·  If software used, 1 RS485 cable with an RJ45 connector and RS232/485 

converter 

·  Pin-hex security screwdriver for secure mounting screws 

·  Slot screwdriver 

2. 

Review terms in the Glossary that are not familiar. 

3. 

Read section 3,”InfoProx Hardware Installation,” before you install the hardware. 

4. 

Familiarize yourself with the unit and the terms as explained in section 4 before 
configuring the unit. 

5. 

Configure the unit, as described in section 4, “Configuring the Door Control Unit.” 
You can accept the defaults for some of these features and can return to 
configuration later to add time zones or to customize the unit. 
 
However, you must configure the time and decide whether they will enter a site 
code for the cards that they will add. The site code is an embedded three-digit 
code issued by the manufacturer with a batch of cards.  

6. 

Setup the unit based on your needs, as described in section 3, ”InfoProx 
Hardware Installation.” 

7. 

Complete a Diagnostic Routine to test the unit. 

8. 

Add assigned cards or PINs to the unit so that personnel may gain access based 
on your access control criteria. 

9. 

Test access and all attached devices.