Huawei Technologies Co. Ltd RRU3232-3650F Manual Do Utilizador
Safety Information
Keep the equipment away from sources of heat or fire, such as the electric heater,
microwave oven, oven, water heater, fireplace, candle or other heat generators. Heat may
cause the equipment to catch fire or its housing to melt.
microwave oven, oven, water heater, fireplace, candle or other heat generators. Heat may
cause the equipment to catch fire or its housing to melt.
Do not obscure or cover running equipment with flammable materials such as paper or
fabric. This hampers heat dissipation and can cause the equipment to catch fire or its
housing to melt.
fabric. This hampers heat dissipation and can cause the equipment to catch fire or its
housing to melt.
Install and use the equipment and its system in a location with restricted access location.
Do not block air vents when the equipment is running. Maintain air vents away from the
wall or other objects as required in the Hardware Installation and Maintenance Guide.
The minimum distance is 5 cm (1.97 in.) unless specified.
wall or other objects as required in the Hardware Installation and Maintenance Guide.
The minimum distance is 5 cm (1.97 in.) unless specified.
Do not use equipment that does not meet IP54 waterproof and dustproof standards in
outdoor environments.
outdoor environments.
1.2.1 Indoor Installation
Ensure that there is no water leakage or condensation from air conditioning failure in the
equipment room on the top of the equipment. Introducing water into the equipment will
cause it to fail.
equipment room on the top of the equipment. Introducing water into the equipment will
cause it to fail.
Install fixed equipment with a large hole at the bottom on concrete, tile or other non-
combustible surfaces.
combustible surfaces.
Prevent rodent and pest infestations at the installation site.
Wall Installation
Before drilling holes on the wall, ensure that there is no circuitry, water pipe, or gas
pipeline in the wall area to be drilled to avoid bodily injury.
pipeline in the wall area to be drilled to avoid bodily injury.
Do not place any flammable or explosive objects above or under the equipment, and do
not obstruct the equipment with foreign objects within a 1-meter (3.28 ft.) radius.
not obstruct the equipment with foreign objects within a 1-meter (3.28 ft.) radius.
Ensure that no hole are drilled that face upwards to prevent water ingress and equipment
damage.
damage.
Ensure that screws are securely installed. Otherwise, the equipment may fall due to
tension after cable connection, causing equipment damage or even bodily injury.
tension after cable connection, causing equipment damage or even bodily injury.
Desktop Installation
Ensure that the desk or workbench is in stable contact with the ground.
Do not put other items on the equipment.
Do not place cups with liquid on or next to the equipment. Spillage may enter the
equipment and pose safety risks. If this happens, immediately stop the equipment, cut off
the power supply, disconnect all cables, and contact after-sales personnel.
equipment and pose safety risks. If this happens, immediately stop the equipment, cut off
the power supply, disconnect all cables, and contact after-sales personnel.
Cabinet Installation
Before installing equipment in a cabinet, ensure that the cabinet is securely fastened with
a balanced center of gravity. Otherwise, tipping or falling cabinets may cause bodily
injury and equipment damage.
a balanced center of gravity. Otherwise, tipping or falling cabinets may cause bodily
injury and equipment damage.
Leave proper clearance around the equipment.
Make sure an enclosed cabinet is adequately ventilated.