Falcom GmbH STEPPII-56 Manual Do Utilizador
STEPP II HARDWARE DESCRIPTION VERSION
1.01
6.1.2.4.1 Why is required to connect a backup battery
The Li-Ion batteries (e.g. 1100 mA/h) provide sufficient current form which
the STEPP II can also continue to operate (except digital outputs, handsfree set
as well heating/cooling system which do not operate only from the external
battery) in case of operating voltage failures. So, in this way it enables the
STEPP II terminal sending/receiving SMS, establishing a data or voice call or
establishing a GPRS connection.
the STEPP II can also continue to operate (except digital outputs, handsfree set
as well heating/cooling system which do not operate only from the external
battery) in case of operating voltage failures. So, in this way it enables the
STEPP II terminal sending/receiving SMS, establishing a data or voice call or
establishing a GPRS connection.
6.1.2.5 Ignition (pin 13)
STEPP II provides two Ignition pins (pin 13) on the Molex and AMP
connectors. Their functionality is the same. The vehicle ignition line (starter
lock clamp 15) can be connected to one of the IGN pins of terminals (Pin
13). Thus, it is possible to send an alarm SMS (by starting the car engine),
prerequisite, the input IGN of the STEPP II should be configured for this
purpose. Both pins 13 on the Molex connector and AMP connector are
internally connected with each other, so they can be alternatively used. For
more information see the corresponding figure in chapter
connectors. Their functionality is the same. The vehicle ignition line (starter
lock clamp 15) can be connected to one of the IGN pins of terminals (Pin
13). Thus, it is possible to send an alarm SMS (by starting the car engine),
prerequisite, the input IGN of the STEPP II should be configured for this
purpose. Both pins 13 on the Molex connector and AMP connector are
internally connected with each other, so they can be alternatively used. For
more information see the corresponding figure in chapter
Note that the STEPP II’s IGN pins are not assumed to switch on the STEPP
II terminal, they are only inputs pin which can be used for specific customer
requirements.
II terminal, they are only inputs pin which can be used for specific customer
requirements.
Figure 11: Ignition connection example
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
Page 32