HIMS International Corporation EB100P Manual Do Utilizador
55
Close
OR
Left-click Exit
Exit program
+
Troubleshooting
1)
When the wireless controller does not work
The main body and the connected controller’s channel setting value
must be set the same for the controller to operate E-bot properly. If
there are two or more E-bots in the same place, settings must be
set differently, so that the controllers do not control the wrong E-bot,
etc.
must be set the same for the controller to operate E-bot properly. If
there are two or more E-bots in the same place, settings must be
set differently, so that the controllers do not control the wrong E-bot,
etc.
Check the Main body channel values
① Please check the channel values on the rear of the Main
body. An Arrow is pointing to the number currently set.
Checking the wireless remote control channel value
① Remove the battery cover from the back of the remote
control.
② Check the channel setting switch. It can set the channel
values as shown in the below picture. Make sure it is set to
the same channel value as the one shown on the main body
the same channel value as the one shown on the main body