SAM Electronics GmbH NG3028X25KW Manual Do Utilizador
RADARPILOT / CHARTRADAR
ED 3038 G 232 / 01 (2002-06)
Operating Instructions
2 Basic Settings; General Remarks about Operating
2.8 Activating/Deactivating of Slave Keyboards/Trackballs
b_r1_e12.fm / 21.06.02
28
2.8
Activating/Deactivating of Slave Keyboards/Trackballs
When a slave monitor is installed together with a trackball and (possibly) a keyboard, this combination
can perform the same functions as the radar indicator to which these units are connected.
can perform the same functions as the radar indicator to which these units are connected.
☞
If there are "radar indicators" on the bridge wings, they are often slave monitors and slave
keyboards/trackballs.
keyboards/trackballs.
If there are one or more slave keyboards or slave trackballs connected to an indicator, only one of them
is active at a time; operating procedures can be performed only on the one that is active.
is active at a time; operating procedures can be performed only on the one that is active.
Activating a Keyboard or Trackball
A non-active keyboard or trackball is activated by pressing the DO key for three seconds.
☞
The keyboard/trackball that had been active up until then is thus deactivated. The associated monitor
acts as a slave monitor.
acts as a slave monitor.
If there is a keyboard present, activation can also be performed by pressing one of the keys RADAR
MODE, CHART MODE or CONN MODE for three seconds. In this case, when the activation occurs, the
switch-over assigned to the key is also performed, see
MODE, CHART MODE or CONN MODE for three seconds. In this case, when the activation occurs, the
switch-over assigned to the key is also performed, see
.