Elkhart Brass Mfg Co Inc PTSS2003 Manual Do Utilizador

The PTSS2003 Transceiver Frequency Hopping Spread Spectrum transceiver. This transceiver should only be
installed by qualified service personnel. The transceiver detects level, low battery or other data signals from the
external binary inputs and broadcasts that data to the system's host receiver.

The PTSS2003 Transceiver is a module as defined by the FCC and therefore must be mounted to another host device
in order to function.

This device is intended only for OEM integrators under the following conditions:

1) The integrator must position this device in any end product such that the antenna to user/bystander distance is
greater than 20 cm when the transmitter is functioning (excluding hands, wrists, feet and ankles).

2)  The transmitter module may not be co-located with any other transmitter or antenna.

As long as the 2 conditions above are met, further transmitter testing will not be required.  However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements required with
this module installed (for example, digital device emissions, PC peripheral requirements, etc.).

IMPORTANT NOTE:  In the event that these conditions can not be met  (for example applications where the
antenna to user distance is < 20 cm or to be co-located with another transmitter), then the original FCC authorization
is no longer considered valid and the FCC ID can not be used on the final product.  In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.

Any Elkhart Brass Mfg. Co., Ltd. customer incorporating the PTSS2003 transceiver module into its own product
must have an external notice affixed to its product. This notice must be placed in a conspicuous location and can use
wording such as: “Contains FCC ID: QT8PTSS2003” or “Contains Transceiver Module FCC ID: QT8PTSS2003”.
Any similar wording that expresses the same meaning may be used.

NOTE:  The end user should NOT be provided any instructions on how to remove or install the device.

The users manual for end users must include the following information in a prominent location "IMPORTANT
NOTE:  To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter."