FreeWave Technologies Inc. 75192031119 Manual Do Utilizador
FreeWave Technologies
User Manual Addendum
421-512 MHz Transceiver
V1.0
LAD0014AA Rev A
1 of 11
FreeWave Technologies Inc.
421-512 MHz User Manual Addendum
The FreeWave Technologies LRS Family 421-512 MHz Licensed Radios operate in
substantially the same manner as the 900 MHz and 2.4 GHz transceivers. The
model numbers; 400LRS-CSU and 400LRS-RC can be used in point to point and
multipoint modes, with essentially the same parameter options.
UL approval for the 400LRS-CSU is not currently available.
Quick Start on a Point-to-Multipoint System
The following is a quick start guide for setting up two transceivers in Point-to-
Multipoint mode. This mode allows for a Master to communicate with several Slaves
simultaneously. In addition to the Quick Start Guide, detailed instructions on how to
set up the frequency and min and max packet sizes are also provided.
NOTE: The following is a step by step procedure for radio setup through
HyperTerminal.
NOTE: The device will be capable of programming through EZConfig at a later date.
When using EZConfig, please reference the tables in this procedure for proper radio
configuration.
1. Connect the transceiver to the serial port of a computer either through a data
Multipoint mode. This mode allows for a Master to communicate with several Slaves
simultaneously. In addition to the Quick Start Guide, detailed instructions on how to
set up the frequency and min and max packet sizes are also provided.
NOTE: The following is a step by step procedure for radio setup through
HyperTerminal.
NOTE: The device will be capable of programming through EZConfig at a later date.
When using EZConfig, please reference the tables in this procedure for proper radio
configuration.
1. Connect the transceiver to the serial port of a computer either through a data
cable (9 pin serial) or via the diagnostics cable.
2. Open up a HyperTerminal session.
• Use the following settings in connecting with HyperTerminal
• Connect to COMx (the COM port to which the cable is connected)
• Set; Bits per second to 19200, Data bits- 8, Parity- None, Stop bits- 1, Flow
control- None.
3. Press the setup button next to the serial port on the radio. If the diagnostics
cable is being used, press Shift-U (capital U).
• The three LED’s on the radio will turn green, indicating Setup mode.
• The three LED’s on the radio will turn green, indicating Setup mode.
• The main menu will appear on the screen.
4. Press 0 to enter the Operation Mode menu.
• Press
2 to set the radio as a point to Multipoint Master.
• Press
3 to set the radio as a point to Multipoint Slave.
• Press
Esc to return to the main menu.
5. Press 1 in the main menu to enter the Baud Rate menu.
• The baud rate in setup mode will be defaulted at 19200.