FreeWave Technologies Inc. 2920513513419 Manual Do Utilizador

 

 

 

1

 

 
 
 
The FreeWave Technologies 2.4 GHz I-Series transceivers operate in substantially the same 
manner as the 900 MHz DGRO9 radio transceiver module.  They may be operated in Point-to-
Point, Multipoint, and Repeater modes. 
 
 
The one difference is that all I-Series transceivers must be installed professionally. 
 
 
 
 

To install the I Series transceiver, follow the basic steps given below.
 

1.

Mount the transceiver to the flat, stable surface using mounting holes in the corners of the 
transceiver.

 
2.

Install the antenna and connect the antenna feedline to the transceiver.  If you are installing a 
directional antenna, preset the antenna’s direction appropriately.

 

 
3. 

Connect a computer to the transceiver’s RS232 port (please, refer to the part D of this 
addendum for more information about the transceiver’s pin assignment).  This computer will 
be used to set the radio’s configurations.

 

 
4. 

Install the power for the radio.

 

 
5. 

Set the radio configuration according to the system topology and data terminal equipment 
requirements.  Default transceiver settings allow user to do a quick installation without major 
changes in transceiver’s configuration.  But there is one parameter that must be considered 
for a new installation  transceiver’s power output settings.

 

Transceiver output power level must be 
satisfy FCC maximum EIRP requirement depending on the antenna used, antenna cable loss 

FreeWave I-

must be provided by FreeWave Technologies.  FreeWave 

l external antennas, with both 

bracket and magnetic mounts. The complete list of antennas available from FreeWave 

characteristics is given in the table below.