Lodar LTD P103-3 Manual Do Utilizador
To register Transmitters to the Receiver
1. Coding into Slot 1
1.
Ensure Receiver is OFF
2.
Press and hold
and
on Transmitter until LED goes
SET
STOP
OFF
3.
LED on Transmitter will flash once to indicate slot 1
4.
Turn
Receiver
ON
5.
Wait for green LED on Receiver to flash slowly
6.
Press and hold
on Transmitter until green LED on Receiver flashes
SET
quickly several times
7.
Check Receiver is coded correctly by pressing SET then operating any function
2. Coding into Slot 2
1.
Ensure Receiver is OFF
2.
Press and hold
and
on Transmitter until LED goes
SET
STOP
OFF
3.
LED on Transmitter will flash once to indicate slot 1
4.
Press
to select slot 2 – the LED on Transmitter will flash twice
SET
5.
Turn
Receiver
ON
6.
Wait for green LED on Receiver to flash slowly
7.
Press and hold
on Transmitter until green LED on Receiver flashes
SET
quickly several times
8
n
.
Check Receiver is coded correctly by pressing SET then operating any functio
If you have any problems please phone either your local Distributor or Lodar directly:-
U
(0)
+1-
K +44
1922 613633. US
877- 257-1581.
Per FCC 15.19(a)(3) and (a)(4) This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
interference received, including interference that may cause undesired operation.
F1
F2
Function uttons
b
SET
Button activates the
Receiver and the keypad
function buttons
4 elease crews for
r
s
attery ompartment
b
c
at rear.
4 x
Alkaline batteries
AAA
Effective working range up to a distance of
60 metres (200 feet) 22 Series
The ransmitter automatically
t
transmits a
signal after
STOP
30 minutes; this de-activates
the eceiver and the ransmitter.
the eceiver and the ransmitter.
r
t
SAFETY FEATURE
!
22TX.0 E.A4
6
!
Instructions for
Series
Transmitters
22
IP
(
)
16 Function shown
utton switches off
STOP b
the eceiver and the keypad
r
function buttons
LED
Blinks when ransmitter
Blinks when ransmitter
t
is active.
when a ransmitter
ON
t
utton is pressed.
b
while transmitting
Pulses
when attery is low.
when attery is low.
b
PRESS
HOLD
&
both
(Red)
STOP
and
(Green)
SET
for a
of
MINIMUM
5 SECONDS
Then
&
PRESS
HOLD SET
for 5 seconds