Digi International Inc XB3C1 Manual Do Utilizador
AT commands
Cellular commands
Digi XBee3 Cellular LTE Cat 1 Smart Modem User Guide
94
Default
-
OA (Operating APN)
Reads the APN value currently configured in the cellular component.
Parameter range
ASCII characters
Default
N/A
AM (Airplane Mode)
When set, the cellular component of the XBee Smart Modem is fully turned off and no access to the
cellular network is performed or possible.
cellular network is performed or possible.
Parameter range
0 - 1
0 = Normal operation
1 = Airplane mode
Default
0
DV (Antenna Diversity)
Set and read the antenna diversity setting of the cellular component. When enabled, the cellular
component uses both antennas to improve receive sensitivity.
component uses both antennas to improve receive sensitivity.
This setting is applied only while the XBee Smart Modem is initializing the cellular component. After
changing this setting, you must:
changing this setting, you must:
1. Use
to write all values to flash.
2. Use
to reset the device.
3. Wait for the cellular component to be initialized:
reaches 0x00.
4. Use FR to reset the device a second time.
5. Wait again for the cellular component to initialize: AI reaches 0x00.
Parameter range
0 - 1
0 - diversity disabled
1 - diversity enabled
Default
1