Orbit Irrigation Product Inc. 25010-11N Manual Do Utilizador

 

 

Press the Reset button to toggle the WiFi signal ON or OFF. 

 

Press and hold the Reset button for at least 8 seconds, then release your finger to reset the router to factory 

default state. Wait until the router reboots, which could take about 3 minutes. 

 

The function of “switch” is configurable by user. 

 
 
FCC Warning  
This device complies with Part 15 of the FCC Rules. Operation is subject 
to the following two conditions  
(1) this device may not cause harmful interference, and  
(2)  this  device  must  accept  any  interference  received,  including 
interference that may cause undesired operation. Changes or modifications 
not expressly approved by the party responsible for compliance could void 
the user’s authority to operate the equipment.  
Note 1: This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to part 15 of the FCC Rules. These 
limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, 
uses and can radiate radio frequency energy and, if not installed and used 
in accordance with the instructions, may cause harmful interference to 
radio communications. However, there is no guarantee that interference 
will not occur in a particular installation. If this equipment does cause 
harmful  interference  to  radio  or  television  reception,  which  can  be 
determined by turning the equipment off and on, the user is encouraged 
to  try  to  correct  the  interference  by  one  or  more  of  the  following 
measures:  
—Reorient or relocate the receiving antenna.  
—Increase the separation between the equipment and receiver.  
—Connect the equipment into an outlet on a circuit different from that 
to which the receiver is connected.  
—Consult the dealer or an experienced radio/TV technician for help.  
Note 2: 1.Changes or modifications to this unit not expressly approved 
by the party responsible for compliance could void the user’s authority 
to operate the equipment. 
 
WARNNING:  The minimum separation generally be used is at least 20 cm, 
even if the calculations indicate that the MPE distance would be lesser.