Highway Technologies Inc 1032 Manual Do Utilizador
Page 4
Elimination of Licensing
The Federal Communications Commission has ruled that Citizens
Band Radio Service operators are no longer required to obtain an
FCC license to operate their CB equipment. In doing so, the FCC
also permits CB stations to operate without station identification.
Elimination of individual station licenses results in no lessening of
the operating privileges or responsibilities of CB users. An operator
of a CB radio station is still required to comply with the Communica -
tions Act and with the rules of CB Radio Service.
Band Radio Service operators are no longer required to obtain an
FCC license to operate their CB equipment. In doing so, the FCC
also permits CB stations to operate without station identification.
Elimination of individual station licenses results in no lessening of
the operating privileges or responsibilities of CB users. An operator
of a CB radio station is still required to comply with the Communica -
tions Act and with the rules of CB Radio Service.
Rules You Should Know
In common with all other CB operators, you must comply with the
general rules prohibiting music, profanity, promotion of illegal activi -
ties, selling of merchandise or services, and blasting others off the
air with illegally amplified transmitters.
Although one-way communications are generally not allowed, oper -
ation of the Wizard for its intended purpose is permitted. Rule 18
(d) provides specific permission to establish one-way communica -
tions concerning highway conditions to assist travelers. An opera -
tor should be monitoring the Wizard at all times.
Since Rule 7 (b) reserves Channel 9 for emergency communica -
tions or travelers assistance, channel 9 may be a good choice as
channel B.
general rules prohibiting music, profanity, promotion of illegal activi -
ties, selling of merchandise or services, and blasting others off the
air with illegally amplified transmitters.
Although one-way communications are generally not allowed, oper -
ation of the Wizard for its intended purpose is permitted. Rule 18
(d) provides specific permission to establish one-way communica -
tions concerning highway conditions to assist travelers. An opera -
tor should be monitoring the Wizard at all times.
Since Rule 7 (b) reserves Channel 9 for emergency communica -
tions or travelers assistance, channel 9 may be a good choice as
channel B.
A second channel is provided to extend cover -
age to one other channel that may be used for
information.
Using the “Channel Selector Knob” select a
SECOND channel on which to alternate trans -
missions. Perform the same procedure as out -
lined above, using the “Channel B” assign but -
ton. The same channel should NOT be
assigned to A and B.
age to one other channel that may be used for
information.
Using the “Channel Selector Knob” select a
SECOND channel on which to alternate trans -
missions. Perform the same procedure as out -
lined above, using the “Channel B” assign but -
ton. The same channel should NOT be
assigned to A and B.
To confirm the channels selected, push the display
channel A or display channel B buttons and observe
the channel number displayed. Release the switch
as soon as the channel selection is confirmed.
channel A or display channel B buttons and observe
the channel number displayed. Release the switch
as soon as the channel selection is confirmed.
CB Broadcast Message
After channels have been selected, select the appro -
priate message in Message panel.
Select “Message Frequency” indicated in seconds. If
30 seconds is selected, the timer will countdown 30
seconds after the completion of each transmissioin to
begin a new transmission. If the channel is busy, it
will take a few additional seconds to wait for a break
in the conversation.
NOTE: The faster the traffic, the more frequently the
message should be sent.
priate message in Message panel.
Select “Message Frequency” indicated in seconds. If
30 seconds is selected, the timer will countdown 30
seconds after the completion of each transmissioin to
begin a new transmission. If the channel is busy, it
will take a few additional seconds to wait for a break
in the conversation.
NOTE: The faster the traffic, the more frequently the
message should be sent.
To Confirm Complete Setup
Set “MODE” switch to “TEST” position. The system
will perform automatically, governed by the current
settings (including timed response and message
selection). The message will be directed only to the
Wizard speaker, not transmitted to the active chan -
nel. If you do not hear the message when the Wizard
is simulating a transmission, set the speaker switch
to “on” and/or turn the volume switch to a higher set -
ting.
If the settings give the desired results, then proceed.
Otherwise, return to the appropriate previous steps.
will perform automatically, governed by the current
settings (including timed response and message
selection). The message will be directed only to the
Wizard speaker, not transmitted to the active chan -
nel. If you do not hear the message when the Wizard
is simulating a transmission, set the speaker switch
to “on” and/or turn the volume switch to a higher set -
ting.
If the settings give the desired results, then proceed.
Otherwise, return to the appropriate previous steps.
Page 9