Cameo Communications Inc DSLR2001N Manual Do Utilizador
Appendix
TRENDnet
DSLR-2001N
102
FCC (Federal Communications Commission)
Statement
Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
help.
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate this equipment. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
by the party responsible for compliance could void the user’s
authority to operate this equipment. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including
interference that my cause undesired operation of this
device.
device.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
conjunction with any other antenna or transmitter.
The availability of some specific channels and/or operational
frequency bands are country dependent and are firmware programmed
at the factory to match the intended destination. The firmware
setting is not accessible by the end user.
frequency bands are country dependent and are firmware programmed
at the factory to match the intended destination. The firmware
setting is not accessible by the end user.