Cameo Communications Inc DSLR2001N Manual Do Utilizador
Setup
TRENDnet
DSLR-2001N
28
DNS Server 1 and DNS Server 2 — If provided by your ISP, enter the
DNS server. Otherwise, leave these fields blank.
DNS server. Otherwise, leave these fields blank.
PPPoE Service Name — Enter a PPPoE service name.
MAC Address — Displays the cloned MAC address. Click the Clone Mac
button to clone the MAC address of your computer.
button to clone the MAC address of your computer.
PPPoE AC Name — Enter the PPPoE account name provided by your ISP.
Connection Trigger — You can configure how you want your Modem
Router to connect and terminate the Internet connection. Options
are:
Router to connect and terminate the Internet connection. Options
are:
•
OnDemand: Enables the Modem Router to cut off the Internet
connection after being idle for a specified period of time.
The Modem Router automatically re-establishes the
connection when you try to access the Internet again. On
the Idle Disconnect Time field, enter the number of seconds
that you want to elapse before your Modem Router terminates
the Internet connection.
connection after being idle for a specified period of time.
The Modem Router automatically re-establishes the
connection when you try to access the Internet again. On
the Idle Disconnect Time field, enter the number of seconds
that you want to elapse before your Modem Router terminates
the Internet connection.
•
AlwaysOn: Enables the Modem Router to be connected to the
Internet at all times. If you are disconnected, the Modem
Router will automatically re-establish the connection.
Internet at all times. If you are disconnected, the Modem
Router will automatically re-establish the connection.
•
Manual: With this setting, you have to enter the user name
and password to establish the Internet connection.
and password to establish the Internet connection.
LCP Interval — Enter the number of seconds that you want to be the
interval in sending LCP (Link Control Protocol) packets.
interval in sending LCP (Link Control Protocol) packets.
As system default route — Check this box to set the current
setting as the default route.
setting as the default route.
ICMP Reply Enable — Check this box to enable ICMP (Internet
Control Message Protocol) messages to be sent back to the host
that sent the message.
Control Message Protocol) messages to be sent back to the host
that sent the message.
Proxy ARP Enable — Check this box to enable proxy ARP function.
Click the Apply button to save your changes or click the Cancel
button to discard your changes.
button to discard your changes.
PPPoA (RFC-2364 PPP over ATM)
If you select PPPoA (Point-to-Point Protocol over ATM), the screen
below is displayed.
below is displayed.