Brady Corporation BC1000 Manual Do Utilizador
Censys: UHF Reader
Censys User Guide March 2017 Version 1.0
Make sure that the wireless network is range (note:
reader does not need to be in final installation
position, although it could be)
reader does not need to be in final installation
position, although it could be)
Click “Submit.” The reader will power-cycle, and
you will see it go through it’s start up sequence
you will see it go through it’s start up sequence
LED will flash red 10 times, go solid red, and then
turn blue once successfully connected to the
network. If successful, reader may be unplugged
and installed in final location without further
configuration.
turn blue once successfully connected to the
network. If successful, reader may be unplugged
and installed in final location without further
configuration.
If LED turns or stays red, it was unable to connect to
your WiFi. Cycle power and repeat this step until
connected.
your WiFi. Cycle power and repeat this step until
connected.
Select the “Un-Assigned Readers” tab.
Your reader should be visible here if properly connected.
From here you can click on “Edit” and assign the reader
to a location within your site hierarchy.
From here you can click on “Edit” and assign the reader
to a location within your site hierarchy.