Advance Security Inc TR13 Manual Do Utilizador
MAY/18/2005
DELUXE 200
REMOTE ENGINE STARTER
WITH KEYLESS ENTRY SYSTEM
INSTALLATION MANUAL
INTRODUCTION
INSTALLER WARNINGS
This Remote Starter with Alarm System is designed to be installed on fuel injected vehicles ONLY.
!
For automatic transmission vehicle, this system must be installed and wired through a safety switch it will
not start in any forward or reverse gear.
!
Some automatic transmission vehicle [mainly older GM vehicles with a purple starter wire] have a
mechanical-type park safety switch instead of electrical safety switch. The mechanical type does not
interrupt the starter circuit when the transmission is any gear and does not offer the 100% level of safety
required for remote starting purposes. Therefore, our system should never be installed on any vehicle that
uses a mechanical type park safety switch.
interrupt the starter circuit when the transmission is any gear and does not offer the 100% level of safety
required for remote starting purposes. Therefore, our system should never be installed on any vehicle that
uses a mechanical type park safety switch.
!
For automatic transmission vehicle, once you install this system, you must verify that the vehicle will not
start any forward or reverse gear. Regardless of the type of vehicle.
!
Read operation manual for operating and programming routine.
!
Do not install any component near the brake, gas pedal or steering linkage.
!
Some vehicles have a factory installed transponder immobilizer system that can severely complicate the
installation. There is possibility that this system can not be installed on some immobilizer equipped vehicles.
!
Most vehicles have an SRS air bag system. Use extreme care and do not probe any wires of the SRS
system.
!
Disconnect the car battery before connecting work on the vehicle.
!
Check behind panels before drilling any holes. Ensure that no wiring harness or other components are
located behind the panels that would otherwise be damaged.
!
Use conventional crimp lock, bullet on any wiring. Poor wiring, i.e. taped joints will possibly introduce
unreliability into the alarm system and may result in false alarms or incorrect operation.
!
Install wiring neatly under carpets or behind trim to prevent possible damage to wires.
!
For the wire operates the current more than 10A. We suggest soldering all connection point. Do not use
crimp lock type connectors or wire nuts.
INSTALLATION DIAGRAM
#H4. 9 PIN WIRE CONNECTION:
DELUXE 200-LCD
1