Askey Computer Corp BLT2010 Manual Do Utilizador
7.5
BTCli
Bluetooth Command Line Interface (BTCli) is a command-line program that lets you send Host Controller Interface
(HCI) commands to your BlueCore device. Host computers use the HCI interface (part of the Bluetooth specification)
to communicate with Bluetooth controllers (e.g. your BlueCore chip).
See the BTCli User Guide for full details.
See the BTCli User Guide for full details.
7.6
RFCli
RFCli is a command line utility for communicating with RFCOMM firmware builds. It enables you to send and receive
RFCOMM primitives to the chip (as well as other protocols). It also has a Tool Command Language (Tcl) interpreter
built in so you can write scripts.
See the RFCli User Guide for full details.
See the RFCli User Guide for full details.
7.7
BCFMRadio
Important Note:
Read the document referenced below before running this program, as you must configure your BlueCore device
before this program will connect to it.
BCFMRadio is a graphical tool for exercising the FM receiver on Bluecore5-FM. It is able to communicate with the
Bluecore using I²C or BCCMDs using BCSP, H4, H4 Deep Sleep, H5, USB and SPI. BCFMRadio provides a user-
friendly interface allowing configuration of the BlueCore5-FM radio.
See Operating the BlueCore5-FM Radio Application Note.
See Operating the BlueCore5-FM Radio Application Note.
7.8
E2BlueCmd
E2BlueCmd is a command-line tool which can read and write from/to EEPROM to initialise the BlueCore
EEPROM header, read and write blocks, and verify EEPROM contents against a file.
E2BlueCmd works over the SPI interface.
Type e2bluecmd -help for usage instructions.
E2BlueCmd works over the SPI interface.
Type e2bluecmd -help for usage instructions.
7.9
DFU Wizard
The DFU Wizard is a program for end users to upgrade the firmware on their BlueCore devices.
7.10 DFU Babel
The USB to SPI Converter (or Babel) transforms the USB packets from the host computer to SPI signals sent out
over Category 5 cable.
DFU Babel is a program that lets you upgrade your USB to SPI Converter with new firmware. If CSR release a
DFU Babel is a program that lets you upgrade your USB to SPI Converter with new firmware. If CSR release a
firmware upgrade for the USB to SPI Converter, you will be able to find it on www.csrsupport.com.
See the USB-SPI Converter User Guide.
See the USB-SPI Converter User Guide.
7.10.1 Upgrading The USB to SPI Converter Firmware
Important Note:
Do not attempt to upgrade a USB to SPI Converter with firmware designed for different hardware (e.g. Casira
firmware). The USB to SPI Converter needs special firmware and any other firmware may make it permanently
unusable.
See the USB-SPI Firmware Upgrade Guide.