Inovonics Wireless Corporation 3B63MB4 Manual Do Utilizador
11
Installation
Notes: Both base stations must be set to the same channel number and different lane numbers.
Base station models C921 and earlier must be mounted at least 25 feet apart. Base station models C922
may be mounted as close as 2 feet apart. Test the system prior to installation by placing the base
stations in the desired locations. Set Jumpers and program the headsets. Insure that the talk L.E.D. on
the proper base station lights when the appropriate (T1 and T2) button on the headset is pressed.
may be mounted as close as 2 feet apart. Test the system prior to installation by placing the base
stations in the desired locations. Set Jumpers and program the headsets. Insure that the talk L.E.D. on
the proper base station lights when the appropriate (T1 and T2) button on the headset is pressed.
Wiring the System
Figure 11. Cross-Lane Wiring Diagram
Programming the Headsets for Cross-Lane Operation
Follow the steps below to program the headsets for Cross-Lane operation, and disable the Talk-Lock function.
It does not matter which base station is used to program the headsets. By pressing T1, the headset will always
communicate with the lane 1 base station; by pressing T2, the headset will always communicate with the lane 2
base station.
It does not matter which base station is used to program the headsets. By pressing T1, the headset will always
communicate with the lane 1 base station; by pressing T2, the headset will always communicate with the lane 2
base station.
1. Disable the Talk Lock function
Talk-Lock is a toggle function that must be checked first to see if it is enabled or disabled. If the Talk LED
lights when the L button is pressed, Talk-Lock is enabled.
lights when the L button is pressed, Talk-Lock is enabled.
• To disable Talk-Lock, turn the headset OFF, press and hold the L button while pressing ON for 5
seconds. You will hear an acknowledging beep.