Inovonics Wireless Corporation 3B63MB4 Manual Do Utilizador

 

16 

The Model C1060 Headset Intercom System can operate on any one of eight different channels.* 

Select a channel that neither receives or causes interference and then program the headsets to that channel using 
the following procedure: 

1.  Pull slightly outward on the lower right side of the base station half–cover and then lift and remove the cover 

as shown in Figure 12. 

 

2.  With the base station turned on, press and release the CHANNEL SELECT switch once.  (This advances the 

system to the next channel.)  One of the red indicators (1–8) will light, indicating the newly selected channel. 

After making any changes to the base station jumper settings, you must press 
the RESET SWITCH to “read” the new settings into the microprocessor. 

  

When two systems are used in a dual lane application, each base station must 
be set to the same channel, and one base station must be set to Lane 1 and the 
other to Lane 2. 

 

If you are installing this as a single lane system, 8 channels on the LANE 2 setting are also 
available for use.