Adtran TRC582TR1 Manual Do Utilizador

TRACER 2xT1 User’s Manual

61280003L2-1B

12

Preliminary

• The installed antenna must not be located in a manner that allows exposure of controlled

personnel to the direct beam path of the antenna at a distance less than 8 feet (2.5 meters).
Installation is on towers, masts, or rooftops and is not accessible to the general population
and;

• the antenna is mounted such that prevents any personnel from entering the area within 8 feet

(2.5 meters) from the front of the antenna.

• It is recommended that the installer place radio frequency hazard warnings signs on the

barrier that prevents access to the antenna.

• Prior to installing the antenna to the RFC output, make sure the power is adjusted to the

settings specified in section 2 of this manual.

•

During antenna installation, be sure that power to the TRACER equipment is turned off in
order to prevent any energy presence on the coaxial connector.

•

During installation and alignment of the antenna, do not stand in front of the antenna
assembly.

•

During installation and alignment of the antenna, do not handle or touch the front of the
antenna.

These simple precautions must be taken to prevent occupation and installation personnel from
exposure to RF energy in excess of specified MPE levels.

Carefully inspect the TRACER for any shipping damages.  If damage is suspected, file a claim
immediately with the carrier then contact ADTRAN Customer Service.  If possible, keep the original
shipping container for use in shipping the TRACER back for repair or for verification of damage during
shipment.

Before beginning installation, verify that all of the following components are present.

Rackmounted RFC configuration:

Provided by ADTRAN

• Baseband processor
• Rackmounted RFC
• BBP to RFC IF interconnect cable
• DS1/DSX-1 interface cables (RJ-48 to RJ-48)

Provided by customer

• Antenna feedline cable
• Antenna and mounting hardware
• VT-100 terminal and RS-232 interface cable (optional)
• 21 to 60 volt DC power source (available from ADTRAN),

either polarity referenced to ground

Mastmounted RFC configuration:

Provided by ADTRAN

• Baseband processor
• Mastmounted RFC
• DS1/DSX-1 interface cables (RJ-48 to RJ-48)

Provided by customer

• Antenna feedline cable
• Antenna and mounting hardware
• BBP to mastmounted RFC IF interconnect cable
• VT-100 terminal and RS-232 interface cable (optional)
• 21 to 60 volt DC power source (available from ADTRAN),

either polarity referenced to ground