Adtran TRC6320 Manual Do Utilizador
612806320L1-1A
Copyright © 2005 ADTRAN, Inc.
91
DLP-1
Connecting a VT100 Terminal or PC to the CRAFT Port
Introduction
TRACER management and provisioning are facilitated by a series of intuitive menus that are accessible on
a computer screen. Connecting either a VT100 terminal or a PC with terminal emulation software to the
a computer screen. Connecting either a VT100 terminal or a PC with terminal emulation software to the
CRAFT
interface (DB-9) on the front of the unit allows access to the menus and management features of
the TRACER. This section specifies how to connect the VT100 terminal or PC to the TRACER.
Prerequisite Procedures
The TRACER must be powered up for terminal communication to function.
Tools and Materials Required
•
A VT100 compatible terminal or PC with terminal emulation software
•
An appropriate cable to connect the TRACER to a terminal
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling it,
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.