Adtran WLAN192XF1 Manual Do Utilizador

Quick Start Guide, 61700954F1-13A, September 2012

1

4

Copyright © 2012 ADTRAN, Inc. All Rights Reserved.

Make sure the following items were included in the shipment: 

•

Bluesocket BSAP 1920/1925 Wireless Access Point (AP)

•

One wall/ceiling mount hardware kit

•

One ceiling T-rail mount hardware kit

The BSAP 1920 has a modular high-efficiency internal Planar Inverted F Antenna (PIFA) antenna (no 

external antenna is required). The BSAP 1925 supports four modular high-efficiency omni-directional 

antennas that support two internal 802.11 radios: a 5 GHz 802.11a/n radio, and a 2.4 GHz 802.11b/g/n 

radio. The antennas can be ordered from ADTRAN in a set of four (two 5 GHz and two 2.4 GHz, 

P/N 1700932F1).

Bluesocket BSAPs should be positioned for maximum throughput and range between other APs and 

wireless client devices. Follow these instructions to mount the BSAP 1920/1925 on the ceiling or drywall 

using the enclosed mounting bracket. To mount the AP to the ceiling or drywall:
1. Attach the mounting bracket to the wall or ceiling using the provided wall/ceiling mount hardware kit.
2. Insert the provided short screws into the bottom cover of the BSAP 1920/1925. Leave enough of 

the screws exposed to ensure that the unit can be attached to the mounting bracket. If extra space 

is required, use the spacers and long screws provided with the T-rail mounting hardware kit to 

increase the space between the unit and the mounting bracket.

By default, DHCP is enabled on the Bluesocket BSAP 1920/1925. If you need to statically configure the 

IP address for the Bluesocket 1920/1925 AP, follow these steps:
1. Ensure that the BSAP is connected to a controlling computer (using the provided RJ-45 Ethernet 

cable).

2. Specify that the computer’s TCP/IP setting is On or Enabled by navigating to Control Panel > 

Network Connections and double-clicking the connection of your network interface card. Select 

Internet Protocol (TCP/IP) and select Properties. Then specify that the TCP/IP setting is enabled.

3. Set your PC to a static IP address of 192.168.190.2 with a subnet mask of 255.255.255.0.
4. Next, access the AP’s command line interface (CLI) using a Secure Shell (SSH) client. Open an 

SSH connection using the unit’s default IP address (192.168.190.1) and port 2335. Enter the default 

user name and password (adm1n (note the number 1) and blue1socket) at the prompt. To access 

the unit using vWLAN, and for more instructions about CLI configuration, refer to the 

.

, available online at