Xmark Corporation TGL Manual Do Utilizador

User Manual - INTRODUCTION

 2003 - eXI Wireless Systems Inc.

Page XX

980-000003 – 002. R1.01

Tag Link Range

The communication range for Tag Link is designed to be typically less than 12
inches. Therefore, it is recommended that the tags be located within 6 to 12
inches of Tag Link. Those tags with ‘off body’ sensor must be placed on the front
panel in the marked area. This will assure that the alarm TIC message is not
transmitted.

Tag Link Functions

The following table lists the functions that are performed transparently in
response to commands from the application software:

COMMAND

TAG LINK ACTION

LED

Power Up

Powers up from sleep mode

none

Power Down

Return to sleep mode immediately or after 30
seconds if no application command

none

Check RF Noise Measures and reports interference at 307 kHz

Measures and reports interference at 433.92 MHz

Green Flashes

Red Flashes

Test Tag TIF

Interrogates tag and returns ID and tag status

See next table

Test Tag TIC

Tag Link waits for TIC signal from specified tag

See next table

Set TLM

Tag Link issues eLink TLM set command

See next table

Disable TLM

Tag Link issues eLink TLM disable command

See next table

Check TLM

Tag Link queries tag and reports rate to application

See next table

Assign MTAG

Reads Mother Tag ID and assigns dynamic ID

See next table

MTAG Bond

Sends baby tag ID(s) to Mother Tag, Mother Tag is
then bonded to the assigned tag(s)

See next table

Each operation is performed for a maximum of 10 seconds. During application
the following audio-visual signals are output:

ACTION

BEEPER

LED’s

Command received

Very short beep

None

Command succeeded

Longer beep

random

Command failed

4 short beeps

Both briefly on