Accton Technology WA4101ACCA Manual Do Utilizador

2-5

Installation Procedures

3. Verify the Access Point Passes the Self Test

Before mounting the access point in its network location, you should first 
verify that it is working properly by plugging it into a power source, or a switch 
that provides Power over Ethernet, and verifying that it passes its self test.

1.

Connect a network cable from a PoE source device (such as a switch) to 
the RJ-45 jack on the back of the access point, or connect the power 
adapter supplied with the access point to the power connector on the back 
of the access point, and then into a properly grounded electrical outlet.

The AP 420 ww/na does not have a power switch. It is powered on when 
the power adapter is connected to the access point and to a power source, or 
when a network cable is connected to the access point and to a network device 
that provides Power over Ethernet. For safety, when connecting to an elec-
trical outlet, the power outlet should be located near the access point.

Use only the AC power adapter supplied with the access point. Use of other 
adapters, including adapters that came with other HP network products, may 
result in damage to the equipment.

Or connect power adapter 

to the power connector

Connect network 

cable to PoE switch