Murata Electronics North America 2410G Manual Do Utilizador
WIT2410
2000- 2005 Cirronet
Inc
38
M-2410-0000 Rev F
After naming the file and clicking on OK, the Capture Data window opens and shows the
amount of data being received. Clicking on Done stops the loading of received data into
the file.
amount of data being received. Clicking on Done stops the loading of received data into
the file.
7.2. Function Keys
All of the function key shortcuts are described below:
F1
Toggles state of DTR (Sleep). State is shown in status line.
F2
Toggles state of RTS. State is shown in status line.
F3
Transmits “:
wit2400
”. Used to enter control mode.
F5
Toggles local echo. If you are transmitting characters through one modem
to another WIT2450, this allows you to see what you are typing.
to another WIT2450, this allows you to see what you are typing.
F6
Toggles stream mode. Causes WinCOM to transmit a repeating pattern of
characters. Useful for testing.
characters. Useful for testing.
F8
Toggles binary mode. Displays extended ASCII and control characters.
Useful for testing.
Useful for testing.
PgUp
Sets data rate of PC serial port to ne xt higher value. Value is displayed in
status line. Useful when WinCOM is used to change the WIT2450
interface data rate. WinCOM can communicate at new data rate without
having to exit and re-enter WinCOM.
status line. Useful when WinCOM is used to change the WIT2450
interface data rate. WinCOM can communicate at new data rate without
having to exit and re-enter WinCOM.
PgDn
Sets data rate of PC serial port to next lower value. Value is displayed in
status line.
status line.