Murata Electronics North America 5811M Manual Do Utilizador
© 2003 Cirronet
Incorporated
24
M-5811-0008 Rev -
5.6. Modem Command Summary
Serial Commands
sd[?|1|f]
Set Data Rate Divisor
sp[?|0|3]
Set Protocol Mode (only 0 and 3)
Network Commands
wb[?|0|1]
Set Transceiver Mode
wl[?|0..ff]
Set Lockout Key
wn[?|00..3f]
Set Hopping Pattern
wg[?|0|1]
Enable Global Network Modes
wp[?|0|1]
Set Transmit Power
wu[?|0|1]
Set Point-to-Point Direct Mode
Protocol Commands
xh,ph[?|00..ff]
Set Hop Duration
(base only)
pr[?|00..ff]
Set Packet Attempts Limit
xw,pw[?|00..ff]
Set Base Slot Size
(base only)
px[?|0|1]
Set ARQ Mode
Status Commands
zb[?|0|1]
Banner Display Disable
zc[?|0|1]
Set Escape Sequence Mode
zh?
Read Factory Serial Number High Byte
zm?
Read Factory Serial Number Middle Byte
zl?
Read Factory Serial Number Low Byte
z>
Exit Modem Control Mode
Memory Commands
m0
Recall
Factory
Defaults
m<
Recall
Memory
m>
Store Memory
m!
Display
Changed
Parameters
Note: Brackets ([,]) as used here denote a set of optional arguments. Vertical slashes separate selections. For
example, given the string wn[?|00..3f], legal commands would be wn?, wn0, wn3, and wn2a. Most
commands which set a parameter also have a ? option which displays the current parameter setting; e.g., wn?.
example, given the string wn[?|00..3f], legal commands would be wn?, wn0, wn3, and wn2a. Most
commands which set a parameter also have a ? option which displays the current parameter setting; e.g., wn?.