Murata Electronics North America BT2022M Manual Do Utilizador
Configuring the Network
Getting Started
A pair of HN-110s is set up by performing the following steps:
• Install the HopNet Wizard configuration program on a PC
• Connect the HN-110 to the PC
• Run a communications test
• Connect the HN-110 to the PC
• Run a communications test
These steps are described in detail below. Other steps you may want to perform
include:
include:
• Change the baud rate
Refer to the Configuring the Network section of this manual for details on these steps.
Install the HopNet Configuration Wizard on a PC.
The HopNet Configuration Wizard is located on the software and documentation CD
included in the HN-110 package. Install the program by inserting the CD in the PC
and following the installation wizard. If autorun has been turned off, double-click on
setup.exe on the CD to start the wizard.
included in the HN-110 package. Install the program by inserting the CD in the PC
and following the installation wizard. If autorun has been turned off, double-click on
setup.exe on the CD to start the wizard.
Connect the HN-110 to the PC.
Connect the serial adapter box to a serial port on the PC using the serial cable
provided.
provided.
Connect one end of the
serial cable to a serial
port on the PC.
serial cable to a serial
port on the PC.
8 HopNet
110