Murata Electronics North America DNT500FP Manual Do Utilizador
www.RFM.com
Technical support +1.800.704.6079
Page 54 of 58
©2008 by RF Monolithics, Inc.
E-mail: tech sup@rfm.com
DNT900 - 11/05/08
6.0 Demonstration Procedure
The procedure below provides a quick demonstration of the DNT500 using a DNT500DK development kit:
1. Confirm that each DNT500P is installed correctly in an interface board, and that the U.FL jumpers
between the DNT500P radios and the interface boards are installed. Also confirm that a dipole
antenna is installed on each interface board, and that J14 has a jumper block installed on each
interface board. See Figures 5.4.1, 5.4.2 and 5.4.3 above.
antenna is installed on each interface board, and that J14 has a jumper block installed on each
interface board. See Figures 5.4.1, 5.4.2 and 5.4.3 above.
2. Attach each transceiver/interface board to a computer with the DNT Wizard program installed.
3. Place the transceivers at least 3 feet (one meter) apart.
4. Start the DNT Wizard program on both computers.
5. On each computer, press the Connect button on the Wizard window. This will open a serial port
setup dialog box. Set the baud rate to 115.2 kb/s and select the COM port the DNT500 is con-
nected to. Parameter values on the left of the Wizard main window and on the Transceiver Setup
tab will fill in.
nected to. Parameter values on the left of the Wizard main window and on the Transceiver Setup
tab will fill in.
6. Select the RF Test tab on the Wizard. A message placed in the Transmit Window is sent to the
specified MAC address each time the Apply button is pressed. Messages received are displayed
in the lower text box. The receive message text box can be cleared with the Clear button.
in the lower text box. The receive message text box can be cleared with the Clear button.