Murata Electronics North America DNT900 Manual Do Utilizador
www.RFM.com
Technical support +1.800.704.6079
Page 38 of 58
©2008 by RF Monolithics, Inc.
E-mail: tech sup@rfm.com
DNT900 - 11/05/08
GPIO_SleepDir
- when GPIO_SleepMode is enabled, this parameter functions as a secondary GPIO_Dir
to set the direction of the GPIOs during a device’s sleep period. This enables the user to provide alternate
configurations during sleep that will help minimize current consumption. Bits 0. .5 correspond to
GPIO0..GPIO5.
configurations during sleep that will help minimize current consumption. Bits 0. .5 correspond to
GPIO0..GPIO5.
GPIO_SleepState
- when GPIO_SleepMode is enabled, this parameter functions as a bitmask to set the
output state of the GPIOs during a device’s sleep period. This enables the user to provide alternate
configurations during sleep that will help minimize current consumption. Bits 0. .5 correspond to
GPIO0. .GPIO5 respecively.
configurations during sleep that will help minimize current consumption. Bits 0. .5 correspond to
GPIO0. .GPIO5 respecively.
PWM0_Init
- this parameter sets the initial value for PWM0 at startup.
PWM1_Init
- this parameter sets the initial value for PWM1 at startup.
ADC_SampleIntvl
- this parameter sets the interval between the beginning of one ADC read cycle and the
next ADC read cycle. The three ADC inputs are read on each ADC read cycle. An ADC_SampleIntvl
count equals 10 ms.
count equals 10 ms.
ADC0. .2_ThresholdLo/Hi
- these values define thresholds to trigger an I/O report based on ADC meas-
urements. If I/O reporting is enabled, a single EVENT report containing the contents of the I/O bank is
generated when a threshold is crossed. Reporting is "edge-triggered" with respect to threshold bounda-
ries, not "level-triggered"; i.e., if the measurement remains there, additional reports are not triggered until
the value crosses the threshold again. The thresholds are met whenever one of the following inequalities
are satisfied:
generated when a threshold is crossed. Reporting is "edge-triggered" with respect to threshold bounda-
ries, not "level-triggered"; i.e., if the measurement remains there, additional reports are not triggered until
the value crosses the threshold again. The thresholds are met whenever one of the following inequalities
are satisfied:
ADCx < ADCx_ThresholdLo
ADCx > ADCx_ThresholdHi
ADCx > ADCx_ThresholdHi
IO_Report Trigger
- when a selected trigger source is enabled, a trigger event will cause the remote to
send an EVENT message to its base containing the entire current values of the I/O Register Bank from
GPIO0 up to and including the EventFlags, but not the PWM settings which are output-only.
GPIO0 up to and including the EventFlags, but not the PWM settings which are output-only.
bit 7
ADC2 high/low thresholds
bit 6
ADC1 high/low thresholds
bit 5
ADC0 high/low thresholds
bit 4
Periodic report timer
bit 3
GPIO3 edge
bit 2
GPIO2 edge
bit 1
GPIO1 edge
bit 0
GPIO0 edge
I/O reporting is supported for remotes only, not the base.
IO_ReportInterval
- when periodic I/O reporting is enabled, this parameter sets the interval between
reports. Units are 10 ms increments, and the default report interval is every 30 seconds.