Murata Electronics North America HN2010 Manual Do Utilizador
HN-2010
Repeater
M-2410-0011, Rev -
HopNet Family of Products
11
Configuring the Repeater
Complete these steps to configure the HN-2010 Repeater to the desired mode:
1.
Remove the back panel of the repeater to set the function. Once the panel is
removed, you should see the following:
• A DB-9 connector
• A 3-way switch
• An LED
removed, you should see the following:
• A DB-9 connector
• A 3-way switch
• An LED
2.
Check the bicolor LED that is directly behind the switch to be sure that it
indicates which configuration mode has been selected and which unit is
being configured. The LED indicator works with the 3-way switch as
follows:
• The red LED will be on when you configure the Base modem
• The green LED will be on when you configure the Remote modem
• Neither LED will be on when you select repeater operation
indicates which configuration mode has been selected and which unit is
being configured. The LED indicator works with the 3-way switch as
follows:
• The red LED will be on when you configure the Base modem
• The green LED will be on when you configure the Remote modem
• Neither LED will be on when you select repeater operation
3.
Flip the 3-way switch to the Remote position and configure that modem as a
remote unit. Refer to Configuring the Network for details.
remote unit. Refer to Configuring the Network for details.
4.
Flip the 3-way switch to the Base position and configure the other modem as
a base unit. Be sure the red LED is on. Refer to Configuring the Network for
details.
a base unit. Be sure the red LED is on. Refer to Configuring the Network for
details.
5.
Once both modems have been configured correctly for repeater mode, set the
3-way switch back to repeater function and the unit should be ready to
operate in repeater mode.
3-way switch back to repeater function and the unit should be ready to
operate in repeater mode.
6.
Verify that the configuration LED is off; then, replace the back panel.
Note: The remote side of the repeater and the base unit with which it is communicating
must have the same network number. The base side of the repeater and the remote units
must also have the same network number and this network number should be different
from that used on the remote side. Additionally, the hop duration used on the remote side
of the repeater must differ from that used on the base side by at least +/- 5 counts of ph
(347 µsec).
must have the same network number. The base side of the repeater and the remote units
must also have the same network number and this network number should be different
from that used on the remote side. Additionally, the hop duration used on the remote side
of the repeater must differ from that used on the base side by at least +/- 5 counts of ph
(347 µsec).