Murata Electronics North America Z2430HPA Manual Do Utilizador
ZMN2405/ZMN2405HP Dev Kit
© 2007-2008 RFM Inc.
30
M-2405-0000 Rev. C-
5.9.1 Config
Tab
The Serial Baudrate sets the communication rate for the UART port of the module. Changes
take effect immediately upon clicking Apply.
take effect immediately upon clicking Apply.
The Model Number field shows whether the device is a Coordinator, Router or End Device.
Friendly Name
is a 16-byte field that allows user-defined names to be assigned to modules for
easier identification in the field. It allows the user to assign applicable names to each radio in
the system, i.e. Main Office for the Coordinator and Pump Well 1 for the Router out on the site
and so on.
the system, i.e. Main Office for the Coordinator and Pump Well 1 for the Router out on the site
and so on.
Sleep Mode
This is used on End Devices Only. Checking this box will configure the module as
a battery-powered sleeping node. The default sleep mode is Timer Sleep. If Interrupt Sleep
mode is desired, it can be selected under the Confg Enable Options tab. This setting should be
configured before the device joins the network. If it is changed after the device has joined the
network, all devices in the network must be power cycled or reset, starting with the coordinator,
to insure the network functions properly.
mode is desired, it can be selected under the Confg Enable Options tab. This setting should be
configured before the device joins the network. If it is changed after the device has joined the
network, all devices in the network must be power cycled or reset, starting with the coordinator,
to insure the network functions properly.
Device Mode
This is currently Read Only. On read back it will be
0x00
for a Coordinator,
0x01
for a Router, and
0x02
for an End Device.
Transparent Mode
A check is this box implements Transparent Mode and allows data without
the CSM packetization to be transmitted. Any data appearing on the serial input will be
transmitted to the coordinator. Data received by the device will also be output by the module
without the CSM packetization. Once you enter Transparent Mode, ZBDemo will no longer work
since it is expecting data to be in CSM packets. See Section 8.2 for details on protocol mode.
Transparent Mode is only for a Router or End Device.
transmitted to the coordinator. Data received by the device will also be output by the module
without the CSM packetization. Once you enter Transparent Mode, ZBDemo will no longer work
since it is expecting data to be in CSM packets. See Section 8.2 for details on protocol mode.
Transparent Mode is only for a Router or End Device.