Proxim Wireless Corporation S58-B60 Manual Do Utilizador

To download locally to an SU: 

1.  From the SU 1.4 or 1.5 Console, select the Download menu. 

2. Select 

Local Firmware. 

3. From 

the 

Look In search field, choose the binary file to be downloaded (PMP_SU_release1-3.mot) 

from the appropriate directory and click Select.  The download requires about 2 minutes.  Once the 
download is complete, the banner indicating Version 1.3 is displayed. 

If the download does not complete successfully, as indicated by a checksum mismatch or a failure to 
reboot, cycle power to the SU and repeat, starting at step 1. 

Use this download method to upgrade BSUs after the SUs have been upgraded to Version 1.3.  The BSU 
is upgraded through its Ethernet/Power cable using the BSU 1.4 or 1.5 Console. 

To locally download to the BSU: 

1.  From the BSU 1.4 or 1.5 Console, select the Download menu. 

2. Select 

Local Firmware. 

3. From 

the 

Look In search field, choose the binary file to be downloaded (PMP_BSU_release1-3.mot) 

from the appropriate directory and click Select.   

4.  Once the upgrade is successful, if there were SUs connected to the BSU, they will re-acquire net 

entry.  For each SU connection, two messages are displayed: 

º  120   Received NetEntry Request from Eth<SU’s Ethernet address> 
º  121   NetEntry completed: Assigned terminal ID<ID#>, VLAN ID 1, IP<SU’s IP address> 

It normally takes less than a minute and a half for the SUs to re-acquire NetEntry with the BSU from 
the time the local download started. 

5.  If there were no SUs connected to the BSU, after the upgrade succeeds, the version banner is 

displayed with version 20021300, following by three messages: 

º  114   Completed flash sector verification 

º  103   DB check completed 
º  107   Save NV configuration Parameters 

Once the SUs are re-connected to the BSU, expect the same behavior as specified in step 4.