Senstar Corporation LM100 Manual Do Utilizador

3. Cut back the negative lead 3 cm (1.2 in.) to offset each power cable so the positive lead is 

longer than the negative lead.

4. Remove 2 cm (3/4 in.) of the insulation from both conductors on each power cable, and from 

both leads of the luminaire.

5. Tightly twist the 3 wires together to form a single conductor, and trim the single conductor back 

to 15 mm (3/8 in.) (i.e., 2 negative conductors from power cables and black lead from 
luminaire; 2 positive conductors from power cables and red lead from luminaire).

6. Insert the single conductor fully into the open-ended connector and verify through the 

translucent connector before crimping.

7. Make the crimp. If the crimp tool you are using does not cover the full length of the internal 

crimp ring make a second crimp.

8. Repeat this procedure for the power cables’ positive conductors and the red lead from the 

luminaire.

9. Temporarily apply power to test the connection.

Figure 22: Stripping the leads

Figure 23: Forming a single conductor

Figure 24: Preparing the splice

Figure 25: Crimping the splice

2 cm (3/4 in.) 1 : 1 scale

15 mm (0.6 in.) 1 : 1 scale

insulation visible

copper wires visible

no visible wires

first crimp

second crimp (if necessary) in-line crimps fully cover the crimp ring